Installation manual. 1. The kit includes the following parts: 1. Remove the upper part of remote controller (Refer to figure 1). Insert a minus screwdriver into the. this operation manual before using the air conditioner. It will tell See also the operation manual included with the indoor unit for details on the. You can read the recommendations in the user guide, the technical guide or the installation guide for DAIKIN BRC1D You’ll find the answers to all your.
|Published (Last):||16 July 2018|
|PDF File Size:||18.56 Mb|
|ePub File Size:||9.5 Mb|
|Price:||Free* [*Free Regsitration Required]|
This operation is unnecessary when setting by group. Do not directly touch the PC board with your hand.
Remote controller Wood screws Installation manual Wall plugs Machine screws manuap. First begin fitting from the clips at the bottom. It’s a community-based project which helps to repair anything.
Refer to figure 4: Long life filter Approx. NOTE When wiring, run the wiring away from msnual power supply wiring in order to avoid receiving electric noise external noise.
The PC board is mounted in the upper part of the remote controller. If required, you can limit the user action by restricting the number of operable buttons. Do not make any settings not given in the table.
Refer to the instruction manual for each optional accessory. Be careful not to damage the board with the minus screwdriver. Refer to figure 5.
Manual BRC1D52 Daikin
Not displayed if the indoor unit is not equipped with that function. Permission level function 6. Setting is carried out in the group mode, however, if the mode number inside the mznual is selected, indoor units can also be set individually. The switch box and wiring for connection are not included.
Set the remote controller before turning the power supply on. During this time the remote controller can not be operated.
P1 and P2 do not have polarity. Refer to figure 8. Reattach the upper part of the remote controller Be careful not to pinch the wiring when attaching.
IM BRC1D52 |
Remove the upper part of remote controller Refer to figure 1 Insert a minus screwdriver into the slots 1 in the lower part of the remote controller 2 placesand remove the upper part of the remote controller. Connect the terminals on majual of the upper part of the remote controller P1, P2and the terminals of the indoor unit P1, P2. Be careful not distort the shape of the lower part of remote controller by overtightening mounting screws.
Change setting when ultra-long filter is installed 2 Thermostat sensor in remote controller 3 Spacing time of display time to clean air filter count setting for when the filter sign is not to be displayed 0 15 25 Approx. The kit includes the following parts: Refer to the chapter “Field settings”.
Wire the indoor unit 1 Refer to figure 6 NOTE indoor unit 2 lower part of the remote controller 3 upper part of the remote controller 4 wired from the rear 5 wired from the top 6 notch the part for the wiring to pass through with nippers, etc.